Tributaries PWRI-X - Manual (Page 4)

E
NGLIS
h
2
Your TRIBUTARIES ® PWRI-X Power Extension Outlet represents the latest in power management and
protection technology. However, like any electronic device, if inappropriately or improperly installed it may
not perform as intended. This product must be installed by a licensed electrician in accordance with the
National Electrical Code. By following a few common sense precautions, your Power Extension Outlet will
give you a lifetime of worry-free performance.
NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL. To reduce the risk of
electric shock, do not attempt to open the case. There are no user-serviceable parts inside.
GENERAL
Please read the safety instructions in this owner’s manual prior to installing the PWRI-X. •
Keep these safety instructions for future reference when operating the PWRI-X. •
Heed all warnings contained in this operating manual and/or printed on the PWRI-X. •
Warning: • to reduce the risk of fire or electric shock, do not expose this equipment to rain or moisture.
Disconnect the power supply cord plug from the AC power source when unused for long periods •
of time.
Only use accessories specified by TRIBUTARIES • ®
ELECTRICAL POWER
Power Sources: The PWRI-X is rated for use with only 15 Amp circuits. •
Install with a minimum of 14 AWG building electrical wire. •
AC power cord: Protect the power cord from being walked on or pinched particularly at plugs. •
Do not overload wall outlets as this can result in a risk of fire or electric shock. •
To completely disconnect this product from the AC mains, disconnect the power cord plug from the •
Neutrik ® AC receptacle or connected Power Manager.
The Tributaries PWRI-X In-wall Power Extension was designed to work with Tributaries Power Managers to
protect remote displays and projectors. The inlet and outlet are UL ® rated and easily install into single gang
wall boxes that are joined together with 14AWG ROMEX building wire. Kits are available with a 6 foot, 9
foot or 12 foot AC power cable terminated with a Twist Lock Neutrik PowerCon ® connector that mates with
the Neutrik ® Twist Lock PowerCon ® inlet.
TRIBUTARIES • ® PWRI-X AC outlet with Decora wall plate and screws for mounting
TRIBUTARIES • ® PWRI-X AC inlet with Decora wall plate and screws for mounting
TRIBUTARIES • ® 14AWG power cable with Neutrik ® Locking PowerCon ® connector on one end and AC
plug on other end
3 Wire nuts for terminating the PowerCon® inlet to in-wall building wire. •
ImporTanT safeTy InsTruCTIons
please read ThIs fIrsT!
produCT InTroduCTIon
paCKaGe ConTenTs