Top Innovations SF-226 - Manual (Page 8)

CONNECTING UTILITY BRUSHES
NOTE: Both Nylon Utility Brushes and the Brass Utility Brush are attached in the same
manner.
1. Begin by aligning hexagonal-shaped hole on back of Utility Brush with hexagonal tip of the
Jet Nozzle (FIGURE 4).
2. Firmly press Utility Brush onto tip of Jet Nozzle (FIGURE 5-A).
IMPORTANT: Make sure accessory is pushed as far as possible onto tip to ensure that it is
properly set in place and space between the accessory and the Jet Nozzle is sealed
(FIGURE 5-B). This prevents heated steam from escaping and causing injury.
3. To remove Utility Brush, make sure unit is unplugged and has had sufficient time to cool down.
Then simply grasp Brush and firmly pull until it disconnects from Jet Nozzle.
8
A
SSEMBLING THE
H
ANDHELD
S
TEAM
C
LEANER
Top Innovations, Inc.
FIGURE 4
FIGURE 5
A
B