Toshiba 151D - Manual (Page 74)

70
TRANSMISSION RESERVATION
When your fax is busy receiving an original or transmitting an original from memory, you can "reserve" a
transmission by setting the original (either in the ADF/RADF or on the document glass), reading it into memory, and
entering the fax number. Once the current operation is completed, your fax will automatically dial the number and
transmit the original saving you from having to wait.
When Using the ADF/RADF:
1
Confirm that there are no originals on
the document glass and that copying
is not in progress, then gently close
the ADF/RADF.
2
Adjust the original guides to the width
of your original.
3
Place the original face up and push it
gently into the ADF/RADF. The top
edge of the original should enter the
fax first.
Adjust the resolution
and/or contrast settings if
desired.
4 Enter the number of the receiving
machine using one of the following
methods:
• Press a Rapid key.
If you press a Rapid Key, the next step is not
necessary.
The number will be dialed once the current
operation is completed, and transmission will
begin once the connection is made.
• Press the [SPEED/SEARCH] key and enter a
Speed Dial number.
• Enter a full number with the numeric keys.
5 Press the [START] key ( ) if you
entered a Speed Dial number or a full
number.
• The number will be dialed once the current
operation is completed, and transmission will
begin once the connection is made.
When placing the Original on the Table:
1
Confirm that there are no original(s) in
the ADF/RADF, and open the
ADF/RADF.
2
Place the original face down on the
document glass. Align the original
according to the original scale in the
illustration below. (Line up the center
of the edge of the original with the
(
) mark.)
3 Gently close the ADF/RADF.
4
If needed, set the original size,
resolution, and contrast. (See
"DIALING AND TRANSMITTING"
(p.59))
5
Press the [START] key ( ) to scan
the page into memory. If you have
more than one original to read into
memory, place the next page, and
press the [START] key (
) to read
each page.
6
Press the [#] key.
Original face up
When using the document glass, do not set
original(s) in the ADF/RADF.
mark
Original
scale
Note