Topcom BUTLER 900 - Manual (Page 8)

5
Operation corded phone
6 Operation corded phone
6.1 Outgoing calls
Making a phone call
Redialling the last number dialled
6.2 Activate/Deactivate the handsfree function
This function allows you to communicate without having to pick up the handset when there is an
incoming call or when you are on the phone by the handset.
6.3 Programming memory numbers
You can program 3 direct numbers M1, M2 and M3 (each of maximum 16 digits) and 10 indirect
memory numbers (0-9) in the corded phone.
6.4 Calling a memory number
This section only describes the working of the corded phone! For the handset
operation, see ”7 Operation cordless handset”.
1 Pick up the handset or press the handsfree key.
2 Enter the desired telephone number.
3 Hang up or press the handsfree key again to terminate the call.
1 Pick up the handset or press the handsfree key.
2 Press the redial key.
The number you last called will be dialled automatically.
1 Press the handsfree key to activate the function.
2 Press the handsfree key again to switch the conversation back to the
handset.
1 Press the memory key.
2 Enter the telephone number you want to store.
3 Press the memory key again to confirm.
4 Enter the direct memory location (M1, M2 or M3) or indirect (0-9) where
you want to store the number.
You will hear a confirmation tone.
If you want to store a pause into the telephone number, press the pause key on
the location where you want a pause of 3 seconds.
1 Pick up the handset or press the handsfree key.
2 Press the direct memory key.
OR
Press the memory key followed by the indirect memory location (0-9).
4 5 6
g h i j k l m n o
4 5 6
g h i j k l m n o
4 5 6
g h i j k l m n o
4 5 6
g h i j k l m n o