Tektronix PHASER 240 - Manual (Page 34)

2 Getting Set Up
2-22 Phaser 240 Color Printer
Startup page
The startup page contains information on printer configuration and error
messages. The printer produces a startup page when you turn on the printer
and self-tests run successfully, if the startup page is enabled (default setting).
The printer takes from 60 to 90 seconds to print the startup page, depending
on the type of transfer roll installed. The READY indicator blinks while the
startup page is printing.
The startup page can be enabled and disabled by sending a utility file to the
printer from the printer’s utilities diskettes. For information, refer to the
Phaser 240 Drivers and Utilities Printing Reference.
Note After the startup page prints, a registration page prints if the
printer has made between six and eight prints since it was built.
If you have not already registered your printer, please do so by
filling out this page and sending it in.
When the printer is ready for operation
When the power-up sequence is complete, both the POWER and READY
indicators remain on, indicating that the printer is ready for operation.