Care and cleaning – Tricity Bendix RE50M User Manual

Page 20

Advertising
background image

ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY AT THE MAIN WALL SWITCH AND
ALLOW THE COOKER TO COOL BEFORE
CLEANING

CLEANING MATERIALS

Before using any cleaning materials on your cooker,
check that they are suitable and that their use is
recommended by the manufacturer.

Cleaners that contain bleach should NOT be used as
they may dull the surface finishes. Harsh abrasives
should also be avoided.

CLEANING THE SEALED HOTPLATES
AND HOTPLATE TRIMS

In order to maintain the appearance of your cooker's
sealed hotplates and trims you are advised to use
the recommended cleaning agents daily. If you do
not allow spillages to burn on they will be much
easier to clean off.

THINGS TO NOTE

The red spot in the centre of the hotplates may be
removed with some abrasive cleaning agents. This is
not a fault and does not affect the performance of the
hotplates.

FOR NORMAL SOILAGE

Wipe over the hotplates and trims using a clean
damp cloth then switch to a low or medium setting for
a few minutes to thoroughly dry.

FOR HEAVY SOILAGE

Use a clean damp cloth or scourer with a cream
cleaner e.g. 'Jif' or a powder cleaner e.g. 'Ajax' on
the hotplate and trims. Follow the circular grooved
pattern on the hotplate when cleaning. Rinse off
cleaning agents thoroughly. Dry as for normal
soilage.

For more stubborn marks warm the hotplate on a low
setting for 30 seconds. Clean the sealed plate with
'Ajax' powder cleaner, 'Jif' cream cleaner or a 'Brillo'
pad. You may have to rub hard for several minutes.

Rinse off cleaning agents thoroughly with a damp
cloth. Switch to a low or medium setting for a few
minutes until the hotplate is thoroughly dry.

CLEANING THE HOTPLATE TRIMS

The stainless steel trims may become straw coloured
during use. Using a proprietary stainless steel
cleaner , e.g. 'Shiny Sinks' will help maintain a bright
appearance. Alternatively a powder cleaner such as
'Bar Keepers Friend' may be used regularly.

CLEANING THE VITREOUS ENAMEL

Use a clean damp cloth or scourer made for non-
stick saucepans with 'Jif' cream cleaner.

AFTER CLEANING

To maintain the appearance of the hotplates
occasionally apply a little salt free vegetable oil or
commercial restorative agent.

To apply vegetable oil, first heat the hotplate on a
medium setting for 30 seconds then turn OFF. Pour
a very small amount of oil onto kitchen paper, apply
the paper to the hotplate and wipe off any excess oil.
Heat the hotplate on a medium setting for 1 minute.

To apply restorative agent, apply a thin coating
of '4 Hob' or use a 'Minky' Hotplate Cleaning Cloth
following the manufacturers instructions.

DO NOT ATTEMPT TO REMOVE ANY OF THE
CONTROL KNOBS FROM THE PANEL AS THIS
MAY CAUSE DAMAGE AND IS A SAFETY
HAZARD.

20

20

CARE AND CLEANING

CLEANING THE OUTSIDE OF THE
COOKER

DO NOT use abrasive cleaning materials eg Hob
Brite, Brillo pads or scourers on the painted or
printed finishes as damage may occur. Regularly
wipe over the control panel, oven doors and cooker
sides using a soft cloth and liquid detergent.

Advertising