Toshiba TLP T521E - Manual (Page 12)

23 22
Preparations
Before connection
• Read the owner’s manual of the device to be connected to the projector.
• Some types of computer cannot be used connected to this projector.
Check for an RGB output terminal, supported signal p.69 , etc.
• Turn off the power of both devices before connection.
• The figure below is a sample connection. This does not mean that all of these devices
can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)
Notes
• COMPUTER terminals 1 and 2 function identically.
• The AUDIO terminal doubles for devices connected to COMPUTER terminals 1 and 2.
Connection How to use the PC card slot
Please read this chapter if the model you purchased includes a PC card slot.
The wireless LAN PC card enables you to connect the projector wirelessly with a
personal computer that supports IEEE802.11b based wireless LAN.
p.33 (Please note
that communication between all the computers based on IEEE802.11b and this projector
is not guaranteed.) You can also use a commercially available memory card to project
JPEG image files using this projector.
p.41 Please follow the steps below when removing
or mounting a PC card.
■ Mounting a PC card
q Remove the PC card slot cover.
Press lightly on the circle (“O”) while
sliding the cover in the direction of the
arrow.
Card slot cover
w Insert the PC card.
After making sure of the card
orientation, press it in firmly until it
stops.
PC Card
e Replace the PC card slot cover.
Replace the PC card slot cover to keep
dust from entering.
■
Removing a PC card
q Look at CARD indicator.
If it is off, proceed to step r .
UNMOUNT button
CARD indicator
w Press the UNMOUNT button.
Begins processing for PC card removal
e Wait until CARD indicator goes
out.
Never remove the PC card while lit.
Doing so could damage the PC card or
corrupt your data.
r Press the Eject button.
The Eject button is a bit stiff, so press
firmly while supporting the projector.
Be careful to avoid injury when doing
so.
Eject button
■
If CARD indicator turns red
Press the RESET switch with a thin pin or
similar implement (it is at the bottom of a
recess).
RESET switch CARD indicator
USB COMPUTER ( Y/P B /P R )
S-VIDEO VIDEO
VIDEO
R - AUDIO - L AUDIO
MONITOR
CONTROL
1 2
p.71
p.52
Computer Desktop computer
To audio output
To USB terminal
USB cable
Audio cable
(for computer)
(supplied)
To RGB
output
Control cable
To RS-232C terminal
Computer (for control)
RGB cable
(supplied)
To Y/C B /C R
output
Green (Y)
Blue (C
B ),
Red (C R )
Yellow
(to video output)
To audio
output
White (L)
Red (R)
VCR
S-Video cable
(not supplied)
AV cable
(supplied)
To S-Video
output
To audio
output
White (L)
Red (R)
To audio
output To RGB
output
Monitor cable
Mini D-sub 15P-BNC
(not supplied)
Audio cable
(not supplied)
DVD player
Conversion
adapter
BNC-pin
(not supplied)