Toshiba ZH36 Series - Manual (Page 16)

Input selection and AV connections
16
Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 5
for a clear view of the back connection recommendations.
Select Ext2 output.
Use Sor Rto change the Ext2 output option to:
Monitor = The picture on screen.
TV = The last television programme selection.
EXT1 = The picture from equipment connected to
Scart 1.
EXT3 = The picture from equipment connected to
the front input sockets.
This specifies the type of signal going into Scart 2 (EXT2)
on the back of the TV. Please refer to the manufacturers
instructions for the connected equipment.
From the Feature menu select EXT2 input
and with
S or R select either Video or
S-VIDEO as the required input.
This enables selection of the source to output from
Scart 2. For example, to record transmissions in stereo
from a stereo decoder – connect a stereo decoder to
Scart 1 and stereo VCR to Scart 2, then select EXT1 as
the Ext2 output. The signal received through Scart 1 will
output directly through Scart 2.
Most VCRs and decoders send a signal through the Scart
lead to switch the TV to the correct Input socket.
Alternatively press the external source selection button
B until the picture from connected equipment is shown.
An S e.g. EXT2S, indicates the input is set for an
S-Video signal.
Press B to select EXT1, EXT2 or EXT3.
EXT1 displays equipment connected to Scart 1.
EXT2 displays equipment connected to Scart 2.
EXT3 displays equipment connected to Input 3 on
the front of the TV.
To return to TV mode press B again or one of the
numbered buttons.
Use the Input Selection if the TV does not switch over
automatically.
Input selection
INPUT signal selection
OUTPUT signal selection for Scart 2
1
1
1
2
2
If the colour is missing try the alternative setting.
Feature menu
EXT2 Input z Video x
Ext2 Output z EXT1 x
Horizontal Position z x
Width z x
Vertical Position z x
Height z x
Panel Lock z Off x
Automatic Format z Off x
Blue Screen z On x
EXIT To Exit fe Select z x Adjust
Feature menu
EXT2 Input z AV x
Ext2 Output z EXT1 x
Horizontal Position z x
Width z x
Vertical Position z x
Height z x
Panel Lock z Off x
Automatic Format z Off x
Blue Screen z On x
EXIT To Exit fe Select z x Adjust