Tributaries HX1RG6 User Manual
Page 5
4.2 Receiver (Rx) Unit
4
3
DC 5V: Connect the 5V DC power supply to the HX1RG6. Then connect the
adaptor to an AC wall outlet
INPUT: Connect the OUTPUT of the transmitter to the INPUT of the receiver
using an RG6 cable terminated with 75 ohm BNC connectors.
Note: Do not use BNC connectors that require screws or clamps to secure the
connector to the cable. For best results only use BNC plugs that are secured
using a Linear Compression Crimping Tool or soldering.
OUTPUT: Connect the output to a 2nd HX1RG6-RX Receiver for cascading up
to 4 times to multiple displays
IR EXTENDER: Connect an IR receiver cable (included) to this input. Place the
eye in front of the display, then use the existing remote to control the source
equipment.
HDMI OUTPUT: Connect an HDMI cable to the display
IR: To use this built-in IR receiver, simply place the receiver in front of the
display and use the existing remote to control the source equipment.
Power LED: This LED indicator will activate once the included 5V DC power
adapter has bee properly connected between the Receiver unit and an open
wall power socket.
1
2
3
4
5
1
2
3
4
5
1
2
3
4
5
6
7
6
7