Thiel Audio Products SS3 - Manual (Page 13)

13
Connect subwoofer power cord, set On switch, auto on switch, set position controls
Subwoofer Setup integrator Adjustment
Is ef
fects channel
level balanced?
Adjust subwoofer
level
Add subwoofer
Finished
Does
subwoofer play loudly enough?
Does
subwoofer play loudly enough?
Listen
Y
N
Y
N
Set Integrator to Crossover mode
If LFE input not used set subwoofer
s
LFE level control to minimum
Set Integrator to Augment mode
Set Main speaker amp gain.
Set crossover frequency
as low as it will go.
Set four Main Speaker
,
# of subwoofers,
# of channels parameters
Connect additional cables
from main speaker amplifier
outputs to crossover
s
speaker level inputs
Connect processor or preamp
outputs to controller inputs.
Connect Integrator outputs to main speaker amplifier inputs
Connect crossover
s or Integrator
s subwoofer
output to subwoofer
s Normal input
YN
If LFE input is used
set main speaker
Amp Gain
Is main
channel bass level
correct?
Adjust Low
Frequency Level
Finished
Increase crossover
frequency
Increase Low Frequency Extension setting, decrease LFE Level setting
or add subwoofer
Y
N
Is ef
fects
channel correct
loudness?
Adjust LFE Level
Y
N
Y
N
Y
N
Do main
speakers play loudly enough?
Listen
enough with
demanding bass?