THB Bury LT 9100 - Manual (Page 5)

6
Device description and installation
7
1. 2.
3. 4.
5. 6.
7. 8.
5. Installation of the Twin-Phone
Installation Overview e.g. with UNI CarTalk
Place the Twin-Phone in the hang-up cup of the Bury hands-free car kit
in order to enable power supply to reach the device. If such supply is
continuous, the device will immediately switch on. If not, the system
will be activated upon ignition and/or starting the engine.
As a default, the Twin-Phone screensaver will be displayed, which also
shows the time and date. In order to ensure that these functions are
continuously provided in case of an interruption to the power supply
(e.g. when removing the Twin-Phone from the hang-up cup), the Twin-
Phone uses an integrated re-chargeable battery. When the car is swit-
ched off (Twin-Phone remains in hang-up cup), the power supply will be
maintained – time and date are still displayed. It is not necessary to
remove the battery as it re-charges automatically once the Twin-Phone
is supplied with onboard power.
In case of an interruption to the power supply (removal from the hang-
up cup), the battery will ensure the time and date are displayed for a
period of approx. 3 to 4 weeks. In case of longer periods of interrupti-
on, the time and date must be reset.
6. Switching off and removing the phone
If you leave your car for a short while, you can set the Turn-off time
function (Setup, System settings, Turn-off time) so that the Twin-
Phone will automatically switch off after a certain period of time. See
the chapter on the respective menu for detailed information.
If you leave your car for longer periods or over night, you should, in
general, never leave the Twin-Phone in the vehicle. This is the best
protection against theft. In order to do so, press the button on the right
side (looking at the phone from above) of your hands-free car kit’s
hang-up cup to release the lock.
If the phone is exposed to direct sunlight while the car is parked, the
inside of the cabin may heat to temperatures exceeding 70°C. For this
reason, remove the Twin-Phone from the hang-up cup and vehicle as
you may otherwise encounter disruptions for a short while once the
Twin-Phone has been switched back on.
7. Steering wheel remote control
You can control the system and enter data via the illuminated steering
wheel remote control (hereinafter referred to as SWRC). The SWRC is
powered by an integrated 3V lithium battery (e.g. CR2). If the battery
housed in part A of the SWRC is low after being used for a long time,
simply replace it with a new, suitable battery.
Part (A)
7.1 Fitting the steering wheel remote control
First, disconnect the parts (A) and (B). Loosen the clamping device of
part (B) as illustrated in the picture. Now place the clamping device on
the steering wheel and re-attach it to part (B). Reassemble the two
parts. The SWRC is now fitted.