TP-Link TL-SL1210 - Manual (Page 6)

2
Uplink ports, and any port can be simply plugged into a server, a hub, a router or a
switch, using the straight cable or crossover cable. Diagnostic LEDs which display
link status and activity, allowing you to quickly detect and correct problems on the
network.
1.2 Features
¾ Complies with IEEE802.3, IEEE802.3u, IEEE802.3ab, IEEE802.3z (for TL-
SL1351 only) standards
¾ 8/16/24/48 10/100Mbps Auto-Sense RJ45 ports supporting Auto-MDI/MDIX
¾ 2/1/2/2 10/100/1000Mbps Auto-Sense RJ45 ports supporting Auto-MDI/MDIX
¾ 1 SFP(Small Form Pluggable) module interface (For TL-SL1351 only)
¾ Supports Auto MDI / MDIX cable detection on all ports eliminate the need for
crossover cable or Uplink port
¾ Non-blocking switching architecture that forwards and filters packets at full
wire -speed for maximum throughput
¾ Supports MAC address auto-learning and auto-aging
¾ Supports IEEE802.3x flow control for full-duplex model and backpressure for
half-duplex transfer model
¾ LED indicators for monitoring power, link, activity, speed
¾ Internal power supply
Chapter 2 Installation
2.1 Mounting the Switch on a Desk
Before place the Switch on a desk, attach four rubber footpads to the flutes on the
Switch bottom, then lay the Switch on the desktop, where can be have as much as
5kg placed on top.
Note:
Make sure there is a grounded AC outlet within 1.5 meters, and working well.
Make sure there is free space for radiating heat and air. Make sure not to place
anything too heavy on top of the switch.