Before you begin, En 2 unpacking the system, Check for moisture – Technicolor - Thomson AM1550 User Manual

Page 6: Choosing system location, Inserting batteries into remote control, Cable connections, Power connections

Advertising
background image

Before you Begin

EN

2

Unpacking the system

Unpack your new mini audio system and locate all the
accessories. You should have:
• one main unit (with 2 speakers);
• one remote control;
• one AM loop antenna;
• one FM wire antenna;
• one guarantee card;
• one user’s guide.

For Thomson model, you should also have;
• one audio cable;
• Thomson Multimedia Pack including MusicMatch
Music Management software (CD-Rom) and a patch
cable to connect your PC. (Refer to the page
“Thomson Multimedia Pack” for details)

Check for Moisture

Just as moisture can form on the inside of windows
on a cold day, it can also form on the inside of your
audio system causing it to malfunction.

If there is any moisture inside the system, the system
may not operate properly. In this case, you are sug-
gested to disconnect the power to the unit and wait
for about 30 minutes for the moisture to evaporate.

Choosing System Location

It is recommended to follow these guidelines when
setting up your system:

• Choose a solid, level surface. Don’t place on surfaces
like carpet or foam rubber.
• Choose a location away from direct sunlight, radia-
tor, air ducts and sources of heat.
• Avoid locations subject to moisture, mechanical
vibration, shock or excessive dust.
• Ensure that the location is adequately ventilated, as
it is essential to protect the unit from internal heat
build-up.

Inserting Batteries into Remote
Control

Open the battery compartment door on the back of
the remote unit and insert correctly 2 AAA (LR03) bat-
teries with + or - signs matching with indications.

To use the remote control, point it directly at the unit.

Cable Connections

Refer to the following for connections on the back
panel:

Power Connections

Plug the power supply cord into an AC power outlet.

Note: For the sake of safety, complete all cable con-
nections before you plug for power.

1. AM Loop Antenna Connector
2. FM Antenna Jack
3. auxiliary Input Jacks
4. Subwoofer Pre-Amp Speaker Jacks
5. Main Speaker Jacks
6. Optical Output

10 cm

10 cm

10 cm

4

SUBWOOFER

PRE-AMP

OUTPUT

1

2

6

4

3

5

@

AM1550 EN rev.1 10/29/01 2:17 PM Page 6

Advertising