Titan Tool 2000XD - Manual (Page 15)

15
IN THE FIELD TECHNIQUES
When pinpointing a target, try drawing an “X”,
as illustrated, over where the tone is induced.
NOTE: This modern Metal Detector is referred to as a Motion Detector since it can respond to a
target only while the searchcoil is being moved over the Target
PINPOINTING
Accurate pinpointing takes practice
and is best accomplished by “X-ing”
the target area.
1. Once a buried target is indicated
by a good tone re s p o n s e ,
continue sweeping the coil over
the target in a narrowing side-
to-side pattern.
2. Take visual note of the place on
the ground where the “ b e e p ”
sounds.
3. Stop the coil directly over this spot
on the ground.
4. Now move the coil straight for-
ward and straight back towards
you a couple of times.
5. Again make visual note of the spot
on the ground at which the
“beep” sounds.
6. If needed, “X” the target at
different angles to “zero in” on
the exact spot on the ground at
which the “beep” sounds.
COIL MOVEMENT
When swinging the coil, be c a re f u l
to keep it level with the gro u n d
about one inch from the surf a c e .
Never swing the coil like a pendu-
l u m .
CORRECT
WRONG
Titan2000MANUAL.qx6 4/22/08 12:29 PM Page 15