Teac A-H300mkIII - Manual (Page 10)

10
Basic Operation
Play the source, and gradually turn up the volume to
the required level by turning the VOLUME knob. 5
Start recording on the cassette tape deck connected to
TAPE 1 or TAPE 2 (or both).
You can use both TAPE 1 and 2 for recording.
< The volume and tone control have no effect on the recording
signals.
3
Recording
3 4
2 1 5
To protect speakers from a sudden high-level signal,
turn the VOLUME knob counterclockwise to minimize
the volume. 1
– ∞ (infinity): minimum volume
0dB: maximum volume
Press the POWER switch. 2
The unit enters standby mode, and the standby indicator
lights.
Press the STANDBY/ON switch to turn the unit on. 3
The standby indicator
goes off.
Select a source by turning the INPUT SELECTOR (or
pressing one of the INPUT SELECTOR buttons of the
remote control unit). 4
Select a source to be recorded by turning the INPUT
SELECTOR.
Do not select TAPE 1 or TAPE 2.
1
Set the REC SELECTOR to “SOURCE”. 2
INPUT SELECTOR
REC SELECTOR