Tripp Lite NetCommander B070-008-19 - Manual (Page 7)

7
Up to 100 ft
Figure 5 NetCommander USB Server Interface Unit
Installation
(continued)
SIU = Server Interface Unit
Connecting a NetCommander USB Server Interface Unit (Model # B078-101-USB)
1. Connect the B078-101-USB VGA connector to the computers VGA port
2. Connect the B078-101-USB USB connector to the computers USB port
3. Connect one end of the Cat5 patch cable to the RJ45 port on the B078-101-USB*
4. Connect the other end of the Cat5 patch cable to the desired RJ45 port on the
Console KVM.* The green LED will illuminate when the SIU is connected
and receiving power.
5. Repeat these steps for each additional USB computer/server you are connecting to the
Console KVM
* Cat5 cable should be no longer than 100 ft.
1. Plug in the KVM using only the power cord supplied with the unit.
2. Switch ON the Console KVM.
To reset the KVM switch, turn the unit off and then back on using the power switch on the
back. The Server Interface Units are unaffected by this reset.
Connecting the Power Supply
Resetting the KVM Switch
201002116 93-2925.indd 7 3/15/2010 11:48:42 AM