Tandberg Data 2U LTO - Manual (Page 4)

StorageLoader 2U LTO Quick Start Guide
Page 4 of 8
Step 4 continued — Powering on and Removing the Shipping Lock
TOP VIEWS FOR REFERENCE ONLY
Important: Some views show the library with the
top cover removed for clarity —DO NOT remove
the top cover or you will void your warranty!
5 — Rotate the robot by pushing the lock handle
toward the back of the library. This moves the
locking “tab” out from under the rail.
a. Gently push the lock handle to the right
approximately 1 inch (2.5cm).
Important: If you do not remove (rotate and lift)
the shipping lock as described in steps b and c,
you can catch and damage cables inside the library
and render it useless.
b. Rotate the back of the lock up toward the
top of the library 2 inches (5cm), and then lift
the front of the lock up 2 inches (5cm).
c. Slowly pull the shipping lock out of the
opening.
6 — Slide the left magazine straight back
into the library.
7 — Power the library on (press the I).
8 — Power the host computer on.
Reinsert the screw in the shipping lock and store
them with these instructions in case you need to
move or ship the library later.