Timex M185 - Manual (Page 22)

 To erase a waypoint, press and hold STOP/RESET .
If you erase a waypoint, it will not re-order the other
waypoints. For instance, if you have labeled your waypoints
WAYPNT 1, 2, and 3 and you erase WAYPNT 2 you will
then have waypoints labeled WAYPNT 1 and 3.
TO OPERATE THE TRACK BACK FEATURE
You can activate the Track Back feature when you are ready to
navigate from a current position to one of your stored waypoints.
When activated, the Track Back feature takes over Waypoints
Mode. You cannot perform any other functions until you
deactivate Track Back.
1. Press ▲ (DISPLAY) to select the desired waypoint.
2. Press and hold START/SPLIT. You will see the message
HOLD TO BEGIN TRACK.
Recall a stored
waypoint
Deactivate Track
Back Activate
Track Back
41
If you attempt to set more than 10 waypoints, you will receive
the message MEMORY FULL.
NOTE: You can also store waypoints in Navigate Mode.
TO VIEW OR EDIT WAYPOINTS
1. Press ▲ (DISPLAY) to recall a stored waypoint.
2. Choose one of the following options to view or edit a waypoint:
 To view a waypoint, press ▲ (DISPLAY) until you locate
the waypoint you wish to view.
You can also continue to press ▲ (DISPLAY) until you
navigate back to the current location.
 To change the label of a waypoint, press SET/FORMAT
until you locate the label you wish to use.
40
View stored
waypoints
Change label for
stored waypoints
E r a s e stored
waypoints