Toastmaster TMBL1134 - Manual (Page 5)

250
500
750
1000
1250
1500
OFF 1 2 3 PULSE
5 4
GETTING TO KNOW YOUR
TOASTMASTER ® BLENDER
PRODUCT MAY VARY SLIGHTLY FROM ILLUSTRATIONS
9.
6.
1.
2.
3.
4.
5.
1. Lid Assembly
2. Lid Insert (P/N 71257)
3. Lid (P/N 71258)
4. Blending Jar (P/N 71259)
5. Gasket (P/N 71260)
6. Blades
7. Collar Assembly (P/N 71262)
8. Collar
9. Motor Housing
10. Control Panel
Figure 1
7.
8.
10.
BEFORE USING FOR THE FIRST TIME
CAUTION: Use extreme care when handling the Blade. Do not
touch the Blades with your fingers. The Blades are very sharp
and can cause injury if touched.
1. Carefully unpack the Blender, Blending Jar, and all parts.
2. Wash the Lid Insert, Gasket, Blending Jar, Lid, and Collar
Assembly in warm soapy water. Rinse and dry thoroughly.
3. Make sure the cord is unplugged and the OFF button has
been pressed.
CAUTION: To protect against risk of electrical shock, do not place
Motor Housing, plug or cord in water or any other liquid.
4. Wipe the Motor Housing clean with a moistened cloth. Dry
thoroughly.
NOTE: Collar Assembly with Blades is a fixed part and cannot be
disassembled.
BLENDER ASSEMBLY INSTRUCTIONS
NOTE: Before assembling, make sure the cord is unplugged.
CAUTION: Use extreme care when handling the Blades. Do not
touch Blades with your fingers. The Blades are very sharp and
can cause injury if touched.
1. Carefully place the Gasket over the Collar Assembly.
2. Set the Blending Jar on top of the Gasket and Collar Assembly.
3. Carefully hold the Collar Assembly with one hand and turn the
Blending Jar clockwise to firmly secure it in position.
NOTE: The Gasket and Collar Assembly must be firmly attached
to the Blending Jar before putting any foods or liquids into
the Blending Jar.
OPERATING INSTRUCTIONS
CAUTION: Keep hands and utensils out of the Blending Jar while
blending to prevent the possibility of severe injury to persons
or damage to the unit. A scraper may be used but must only be
used when the unit is not running.
CAUTION: Use extreme care when handling the Blades. Do not
touch Blades with your fingers. The Blades are very sharp and
can cause injury if touched.
1. Before starting, make sure power cord is unplugged and the
OFF button has been pressed.
TMBL1134 Manual 8/24/06 2:08 PM Page 4