Subscriber unit basic settings – Trango Broadband M5580M-FSU User Manual
Page 14
Configuration
Trango Broadband Wireless — M5580M-FSU (Atlas Fox) User Manual Revision 2
page
10
Subscriber Unit Basic Settings
Log into the SU. To receive a comprehensive snapshot of the system’s configuration info and status, type the
command sysinfo.
#> sysinfo
[Hardware Version] 5580
[MVC Version] 3893mvc_4p5_050913.arm
[Firmware Version] AFSU 2p0r8D06011801
[Device ID] 00 01 DE 00 04 3F [Base ID] 1 [AP ID] 1 [SU ID] 1
[System Up Time] 0 day(s) 00:00:39
[Opmode] off [Default Opmode] off [Opmode Start] 30 sec
[IP] 192.168.100.100 [Subnet Mask] 255.255.255.0 [Gateway] 192.168.100.1
[Httpd Port] 80 [Httpd Status] listen
[Telnetd Port] 23 [Telnetd Status] connected
[Telnet Client #1] 192.168.100.177,1637
[Tftpd] disabled
[RF Tx Power] 17 dBm
Channel Table: (MHz)
[Ch#01] 5736 [Ch#02] 5756 [Ch#03] 5776 [Ch#04] 5796 [Ch#05] 5816 [Ch#06] 5836
[Ch#07] 5736 [Ch#08] 5736 [Ch#09] 5736 [Ch#10] 5736 [Ch#11] 5736 [Ch#12] 5736
[Ch#13] 5736 [Ch#14] 5736 [Ch#15] 5736 [Ch#16] 5736 [Ch#17] 5736 [Ch#18] 5736
[Ch#19] 5736 [Ch#20] 5736 [Ch#21] 5736 [Ch#22] 5736 [Ch#23] 5736 [Ch#24] 5736
[Ch#25] 5736 [Ch#26] 5736 [Ch#27] 5736 [Ch#28] 5736 [Ch#29] 5736 [Ch#30] 5736
[Channel Scan Sequence] 5 v
[Active Channel] 5 v Disconnected
[Broadcast Packet] on [Auto Scan AP] on [TCP/IP for AP] off [TCP/IP for Local Eth] off
[Remarks] Remarks
[ARQ] on
[RF Rx] 0 Kbps [RF Tx] 0 Kbps [Eth Rx] 0 Kbps [Eth Tx] 0 Kbps
[Eth Rx] 1,629 bytes [Eth Tx] 2,812 bytes
[RF Rx] 0 bytes [RF Tx] 0 bytes
Success.
Many of these parameters can be changed by the user. A description of each of these changeable parameters,
along with the related command, is shown in table #3 below.
Table 2: Reference Table of Basic SU System Information
SU SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS
SU Parameter
Description
Related CLI Command
Device ID
MAC Address of the SU
N/A
Base ID
Specifies the cell or cluster to
set baseid <baseid>
which the SU belongs.
Example: #>Set baseid 10
SU ID
Together with Base ID, it is
the unique identifier of this SU
set suid <suid>
used in association. It is used
Example: