T+A Elektroakustik DD 1535 R - Manual (Page 21)

21
Speaker Position Menu
In the 'Speaker Position Menu' you can enter the
distance from the listening position (in 0.3 m increments)
for each loudspeaker separately. This enables the decoder to compensate for timing
discrepancies due to differences in speaker location.
Recommended loudspeaker arrangement
5.1 Loudspeaker set 7.1 Loudspeaker set
30° 30°
60°
45°
90°
45°
60°
TV
Surround
left
Back speaker
left
Surround
right
Back speaker
right
Centre
Front Box
left Front Box
right
Sub-woofer
/ / / / STOP
OK
2.40 m
2.10 m
2.40 m
2.40 m
2.40 m
2.40 m
2.40 m
2.40 m
Select
menu point
Spk position
return to Loudspeaker menu
Front left
Front center
Front right
Surnd right
Back right
Back left
Surnd left
Subwoofer
Measure the distance between the listening position and
the loudspeakers in your surround system, and enter the
measured distances.
Note:
The maximum distance of a loudspeaker to the listening
position is 12 m. For acoustic reasons greater distances
cannot be recommended, and the system cannot
compensate for timing errors over a range greater than
12 m.
As the illustration shows, you use the select buttons to
move to the input positions in the following sequence.
Output channels not in use (see 'Loudspeaker Menu')
cannot be edited.
Use the change buttons to enter the measured distance
in increments of 0.3 m.
• Main loudspeaker front left (front left)
• Center loudspeaker front center (front centre)
• Main loudspeaker front right (front rear)
• Surround loudspeaker right (surnd right)
• Back loudspeaker right (back right)
• Back loudspeaker left (back left)
• or back loudspeaker centre (back centre)
• Surround loudspeaker left (surnd left)
• Active subwoofer (any position) (Sub)