Feature identification – Tripp Lite PowerVerter RV612ULH User Manual

Page 4

Advertising
background image

4R

Feature Identification

Identify the premium features on your specific model and quickly locate instructions on how to maximize their use.

Configuration DIP

Switches:

optimize Inverter/Charger

operation depending on your application. See Configuration
section for setting instructions.

Operating Mode Switch: controls Inverter/Charger operation.
The “AUTO/REMOTE” setting ensures your equipment
receives constant, uninterrupted AC power. It also enables the
Inverter/Charger to be remotely monitored and controlled with
an optional remote module (Tripp Lite model APSRM4, sold
separately or included with select models). The “CHARGE
ONLY” setting allows your batteries to return to full charge faster
by turning the inverter off which halts battery discharging. See
Operation section for setting instructions.

“LINE”, “INVERT”, “LOAD” LEDs: intuitive “traffic light”
signals show whether the Inverter/Charger is operating from AC
line power or DC battery power. It also warns you if the
connected equipment load is too high. See Operation section for
instructions on reading the indicator lights.

“BATT VOLT/CHRG CURR” LEDs: these three lights will turn
ON in several sequences to show two separate operational condi-
tions depending on the position of the Operating Mode Switch. See
Operation section for instructions on reading indicator lights.

DC Power Terminals: connect to your battery terminals. See
Battery Connection section for instructions.

Ground Fault Interrupter (GFI) AC Receptacles (not on
hardwire models): allow you to connect equipment that would
normally be plugged into a utility outlet. They feature ground
fault interrupter switches that trip if there is excessive current
on the ground safety wire.

AC Input Cord (not on hardwire models): connects the
Inverter/Charger to any source of utility- or generator-supplied
AC power. See AC Input/Output Connection section for instructions.

Hardwire AC Input/Output Terminals (not on corded
models): securely connect the Inverter/Charger to vehicle or
facility electrical system input and recommended GFI receptacle
output. See AC Input/Output Connection section for instructions.

Resettable Circuit Breaker: protect your Inverter/Charger against
damage due to overload. See Operation section for resetting
instructions.

Remote Control Module Connector: allows remote monitoring
and control with an optional module (Tripp Lite model
APSRM4, sold separately or included with select models). See
remote module owner’s manual for connection instructions.

Battery Charge Conserver (Load Sense) Dial (not on 612
models): conserves battery power by setting the low-load level
at which the Inverter/Charger’s inverter automatically shuts off.
See Configuration section for setting instructions.

Main Ground Lug: properly grounds the Inverter/Charger to
vehicle grounding system or to earth ground. See Configuration
section for instructions.

Multi-Speed Cooling Fan: quiet, efficient fan prolongs equipment
service life.

Hardwire AC Input/Output Cover Plate

Battery Temperature Sensing Connector (not on 612 models):
prolongs battery life by adjusting charge based on battery tem-
perature. Use with cable (included on select models). See
Configuration section for details.

Automatic Generator Start Connector (not on 612 models):
automatically cycles generator based on battery voltage. Use
with user-supplied cable. See Configuration section for details.

1

2

3

4

5

6

7

8

9

10

HOT IN

NEUTRAL IN

GROUND IN

GROUND OUT

HOT OUT

“FOR USE WITH COPPER WIRE ONLY”

NEUTRAL OUT

1

2

4

3

5

9

8

Front View (Single Input/Output Hardwire Models)

12

Rear View (Single Input/Output Hardwire Models and Select Corded Models)

1

2

4

3

5

9

Front View (Dual Input/Output Hardwire Models)

Front View (Corded Models)

* 612 models have only one set of DIP Switches. ** Select models include front-mounted ground lug. † Available on all models except 612 models.

2

4

3

5

6

7

9

12

**

8

Side Mounted,
Not Shown

Side Mounted,
Not Shown

Side Mounted,
Not Shown

Side Mounted,
Not Shown

11

12

13

14

15

16

13

1*

10

11

15

16

13

10

11

15

16

14

13

12

11

15

16

10

200502023 RV Series Inverter-Charger Owner’s Manual.qxd 3/7/2005 7:42 PM Page 4

Advertising
This manual is related to the following products: