TOA Electronics B-40REN - Manual (Page 4)

4 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Figure 5
CAUTION: DO NOT ATTEMPT TO TOUCH THE
DOORS WITH YOUR HANDS WHILE THE FIRE-
PLACE IS IN USE. ALWAYS USE DOOR
HANDLES. DOORS WILL BECOME VERY HOT
WHEN FIREPLACE IS IN USE.
WARNING: FIREPLACES EQUIPPED
WITH OPTIONAL ACCESSORY DOORS
SHOULD BE OPERATED ONLY WITH
THE DOORS FULLY OPEN OR FULLY
CLOSED (
FIGURE 4 ). THIS APPLI-
ANCE MAY ONLY BE FITTED WITH
DOORS CERTIFIED FOR USE WITH
THE APPLIANCE.
Figure 4
AVERTISSEMENT: POUR UTILISATION
UNIQUEMENT AVEC LES PORTES EN
VERRE CERTIFIÊES AVEC L'APPAREIL.
Figure 3
COMBUSTION AIR CONTROLS
Many appliances are equipped when installed
with an outside combustion air vent system
that is designed to provide the appliance with
outside make-up air for combustion when in
operation.
WARNING: DO NOT USE ABRASIVE
CLEANERS. NEVER CLEAN THE GLASS
WHEN IT IS HOT.
4. Always turn off gas to the pilot (millivolt
appliances) before cleaning. Before re-light-
ing, refer to the lighting instructions in this
manual. Instructions are also found on a pull-
out panel located on the floor of the appliance.
5. Always keep the appliance area clear and free
from combustible materials, gasoline and other
flammable liquids.
6. Remember, Millivolt appliances have a con-
tinuous burning pilot flame. Exercise caution
when using products with combustible vapors.
7. Clean the optional glass doors only when
necessary. Wipe surface with clean, damp-
ened, soft cloth. Follow with dry, soft towel as
desired. Take care not to scratch the glass
surface.
Honeywell Electronic
Gas Valve
Combustion
Air Actuator
ON/OFF Switch
Electronic
Gas Control
Valve
Inlet
Pressure
Port
Manifold Pressure Port
OFF
IN
PSI
ON
CONTROL
IG
N
IT
E
R
Fully Open or
Fully Closed
Spark Ignitor
SIT Millivolt Valve Gas Control Knob
O
N
OF F
P I L
OT
Gas Control Knob Spark Ignitor
Honeywell Millivolt Valve
IN OUT
TPTH
TP
TH
PI
LOT
PI
L O
T
ON
it
OFF
Figure 2
If the appliance is not equipped with a wall
switch or remote control, the main burner must
be turned off and on with the gas control
switch. Toggle the switch from ON to OFF to
operate the main burner from ON to OFF.
2. When lit for the first time, this appliance will
emit a slight odor for an hour or two. This is
due to the “burn-in” of internal paints and
lubricants used in the manufacturing process.
3. Keep lower control compartment clean by
vacuuming or brushing at least twice a year.
More frequent cleaning may be required due to
excessive lint from carpeting, bedding materi-
als, etc. It is important that control compart-
ments, burners and circulating air passage-
ways of the appliance be kept clean.
The actuator for combustion air system is
standard on all appliances but must not be
operated if the complete system is not in-
stalled. Refer to
Figures 5 and 6. When the
complete outside combustion air vent system
is installed, the installer will remove the actua-
tor locking screw.