Technika 23-231-BB - Manual (Page 9)

IMPORTANT NOTE. Occasionally we may release new software/firmware upgrades/enhancements
for this television. Please check the ‘firmware upgrade’ section of the website regularly.
9 9
ATTACHING/DETACHING THE STAND
fi g 1
fi g 2
For optimum viewing, if wall mounting the TV
higher than eye level, the TV should be tilted
downwards so that the TV’s screen is ‘face on’.
See fi g 1 and 2
Attaching the Stand
1) Insert the TV into the stand at 45 degrees 2) Twist the TV into the CLOSE
position until it clicks into place
This television requires a VESA 100 wall mount, or equivalent.
Detaching the Stand
1) To remove the base, press close and rotate 45 degrees.
2) Remove the 4 screws highlighted
IMPORTANT - Before drilling any holes in the wall ensure you are not drilling
where there could be any electric wires, water or gas pipes.
Wall mounting the TV
1) Remove the four screws highlighted below.
2) The wall mount can now be easily attached to the mounting holes on the rear of the TV. These holes
are indicated in the picture below.
Important – If wall mounting this TV, only
use the screws already provided in the wall
mounting holes. Using other screws which
are longer could cause irreparable damage to
internal parts.
TV
TV
Viewing angle
Viewing angle
Attaching / detaching the stand and wall mounting
3) Remove the screw/s in the neck of
the stand (where fi tted)
TEchnika Manual 23-50 colour models .indd Sec1:9 TEchnika Manual 23-50 colour models .indd Sec1:9 20/01/2010 14:11:07 20/01/2010 14:11:07