Network, 3 network – TANDBERG 1000 MXP User Manual
Page 184
D1372202_T1000_MXP_User_Manual
176
Headset
1 headset connector, 2.5mm 3-pole mini-jack.
The headset plug must have the following configuration:
Tip:
microphone output
Ring:
earphone (receiver input)
Sleeve:
common/ground
Headsets with the microphone positioned in front of the user
’
s mouth, connected to the earphone
through a rod, tend to give more echo than earbud headsets with the microphone attached to the
cord. TANDBERG recommends the Plantronics MX100 headset (
www.plantronics.com
, products
→
mobile).
5.1.3
Network
Ethernet:
1 x Ethernet (RJ-45 Jack) LAN interface (10/100 Mb) up to 768kbps
To connect the system to a LAN, use the Ethernet cable provided by TANDBERG (or a standard
Ethernet cable).
The cable specification is:
1 ------------ 1
2 ------------ 2
3 ------------ 3
6 ------------ 6
If no LAN is available and the codec is connected directly to a computer, use a crossover cable.
The crossover cable specification is:
If such a connection is needed, the system and the PC must use
‘
static
’
TCP/IP settings because
no DHCP server is controlling the small
“
LAN
”
, which has been created between the computer
and the system. When configuring a back-to-back connection between the PC and the system,
make sure both static IP addresses exist on the same subnet.
ISDN BRI Interface: