Thermos 461230404 - Manual (Page 20)

20 • 461230404
CAUTION
If burner does not light, turn knobs to , wait 5
minutes, and try again. If the burner does not ignite with
the valve open, gas will continue to flow out of the burner
and could accidently ignite with risk of injury.
OFF
Burner Flame Check
• Remove grates and flametamers. Light burner, rotate knobs
from HI to LOW. You should see a smaller flame in LO position
than seen on HI. Always check flame prior to each use.
Perform flame check on sideburner. If only low flame is seen
refer to "Sudden drop or low flame" in the
.
Troubleshooting
Section
HI
LO
Ignitor Lighting The Sideburner
Match Lighting
s Do not lean over grill while lighting.
1.
2.
3.
1.
2.
3.
To ignite sideburner, open sideburner cover.
Turn sideburner knob to HI, push and hold ELECTRONIC
IGNITOR button.
If sideburner does NOT light, turn knob to OFF, wait 5 minutes,
then repeat lighting procedure or use match.
To match light sideburner, open sideburner cover.
Place lit match near burner.
Push in and turn sideburner
knob counterclockwise.
Be sure burner lights
and stays lit.
Turning Grill Off
Ignitor Check
Valve Check
Hose Check
General Grill Cleaning
• Turn all knobs to position. Turn LP tank off by turning
hand-wheel clockwise to a full stop.
Press and hold electronic ignitor
button. "Click" should be heard and spark seen each time
between collector box or burner and electrodes. See
if no click or spark.
. Knobs lock in position. To check valves, first
push in knobs and release, knobs should spring back. If knobs
do not spring back, replace valve assembly before using grill.
Turn knobs to
position then turn back to position.
Valves should turn smoothly.
Before each use, check to see if hoses are cut or worn.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.
• Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory
. Apply a strong solution
of detergent and water or use a grill cleaner with scrub brush
on insides of grill lid and bottom. Rinse and allow to completely
air dry.
• Wash with warm soapy water and wipe dry.
Do not use citrisol, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic parts. Damage to and
failure of parts can result.
Because of glass-like composition, most
residue can be wiped away with baking soda/water solution or
specially formulated cleaner. Use nonabrasive scouring powder
for stubborn stains.
Wash with mild detergent or nonabrasive
cleaner and warm soapy water. Wipe dry with a soft
nonabrasive cloth.
To maintain your grill’s high quality
appearance, wash with mild detergent and warm soapy water
and wipe dry with a soft cloth after each use. Baked-on grease
deposits may require the use of an abrasive plastic cleaning
pad.
• Turn gas off at LP tank.
• Important: Make sure gas is off at LP tank before checking
valves
LO
•
(and should never be painted)
Do not apply a caustic grill/oven cleaner to painted
surfaces.
Plastic parts:
• Porcelain surfaces:
• Painted surfaces:
• Stainless steel surfaces:
"Troubleshooting"
s
OFF
OFF
OFF
Match-Lighting
s Do not lean over grill while lighting.
1. Open lid.
2.
3.
4.
Turn on gas at LP tank.
Place lit match into match lighting stick, then into lighting hole
on left and/or right side of grill.
Push in and turn right or left burner knob to HI. Be sure burner
lights and stays lit.
Light adjacent burners in sequence by pushing knobs in and
turning to HI.