SoundMax SM-LCD711 - Manual (Page 11)

11
c. Band: You may choose the band where to search the channel. You
can choose V-L, V-H, UHF, and return to Program No.0 upon
completion.
d. Swap: Press CH+/CH- buttons to choose the program swap item.
The function allows you to swap the current channel number to
another one. Press CH+/CH- buttons to choose target channel (it
means the channel has been chosen, when the color of the channel
number's change to red), press VOL+/VOL- buttons to add or
reduce the number, then press CH+/CH- buttons to choose current
channel number, press VOL+/VOL- buttons to realize the function.
e. Fine: press CH+/CH- buttons to choose this item, then press
VOL+/VOL- buttons to adjust the program conditions while you are
watching by hand.
f. Search: press CH+/CH- buttons to choose this item, then press
VOL+/VOL- buttons to proceed to search channels by hand.
g. Auto-Search: press VOL+/VOL– buttons to start AUTO-SERACH, put
into automatically memory and storage upon completion of AUTO-
SEARCH.
Note: AUTO-SEARCH Start from Program No.0. When receive signal
under Search, the Program Indication Bar should turn from red into
green, which means the optimum position for signal storage. If channel
under weak signal is received, the channel storage system will
automatically identify it as no signal.
Caution:
1. When performing manual search, press VOL+/VOL- buttons can
reverse the searching direction. Press MENU to stop manual search.
2. Use CH+/CH- buttons to select channel number. If a channel is
preset, the channel number will become red.
Note:
1. Hue setting applies to NTSC input only.
2. Volume can simply be adjusted by pressing VOL+/VOL- buttons.
3. OSD menu will automatically exit in 10 seconds.
In order to receive clearer picture
Adjust the length, angle and direction of the telescopic antenna to
obtain optimum image. Draw back the antenna from the butt end after
usage.
Caution: In case the signal intensity is too weak, the image will remain
inferior whatever you adjust the antenna, and cause loud noise wave,
shaking image and inferior sound, etc., which is not TV fault. If the
image remains inferior when using telescopic antenna, please try to use
the external antenna or CATV.