Technicolor - Thomson 30LB120S4 - Manual (Page 14)

14
5. OPERATION
General operation
Switching the TV set on and off
To switch the TV set on, press the button located on the right side of the set.
When the set is on, the indicator on the front is green.
Standby mode
Press the
button on the screen right side of TV or on the remote control.
The TV set remains powered up, but with low energy consumption.
When the TV set is in standby mode, the indicator on the front is red.
Quitting standby mode
- Press the
or any numeric button on the remote control,
- press the PR+/PR- buttons to switch on the television at the last channel or AV programme you were watching,
- press the AV button to switch the television on at the last AV programme you were watching.
Volume
Volume control: use the VOL + / - buttons on the right side of the TV set or press the same buttons on the
remote control to increase or decrease the volume.
Sound mute: press the
button to temporarily mute the sound. Press this button again or the VOL
+ button to
restore it.
Displaying status information
In TV mode, press the yellow button (INFO) on the remote control to display the number and name of the
channel you are watching, the type of sound, the zoom or format type, sound mute status and the sleep
timer status (if active).
TV lock message is displayed if the function is activated under the PREFERENCES menu.
When you switch on the television or change channels, the number and name of the channel are displayed if you
entered its name under the ORGANISER
menu.
In PC and PIC(see page
21) modes, press the yellow button (INFO) on the remote control to display the
Resolution ,Vertical and Horizontal frequency.
Accessing channels
Using the numeric buttons:
- for channels 1 to 9, press the corresponding button.
- for channels 10 to 99, press the 0 button to display “--“, then enter the two digits.
Using the PR+/PR-
buttons: scroll through the channels.
AV programmes are not included in the cycle unless you use the buttons on the right side of the TV set.
Accessing AV programmes
Press the AV button to display the last selected audio-visual programmes and scan through the other audio-visual
programmes.
AV selections loop : AV1, AV1RGB, AV2/AV2-S, AV3, AV3-S, YCrCb, YPrPb, DVI
Nota : If you select PC when an YPrPb signal is available on D-sub socket, the displayed picture will
be green. You must select YPrPb.
(Depending on model), PC.