Т³гж 2, Chapter 1 introduction, Hardware overview – TP-Link TF-3239D User Manual

Page 2: Features & benefits, Fcc statement, Copyright & trademarks, Ec declaration of conformity (europe), Safety notices

Advertising
background image

1

2

Thank you for purchasing TF-3239 series 10/100M Fast Ethernet

Adapters. This guide is to provide the installation and usage of the

Products for network installers or users. The Product complies with

PCI 2.1/2.2 specification and supports half/full duplex feature which

can double network speed.

The Adapters support both 10Mbps and 100Mbps network speed,

100Base-TX operates on twisted pairs of Category 5 UTP and 10Base-

T operates on Category 3, 4, 5 UTP. The Products use Auto-

Negotiation technology to detect the network speed. Extensive driver

supports for including commonly used network operation system

Netware, Win9x,Win2000, Windows NT, and TCP/IP are available.

This manual is divided into two chapters and two appendices. The

following summarizes the contents of the chapters and appendices.

Chapter 1 Introduction

Hardware Overview

TF-3239 series Adapters are highly integrated and cost-effective

single-chip Fast Ethernet Adapter that provides 32-bit performance,

PCI bus master capability, and full compliance with IEEE 802.3u

100Base-TX specifications and IEEE 802.3x Full Duplex Flow Control.

They also support ACPI, PCI power management for modern

operating systems that is capable of Operating System Directed Power

Management (OSPM) to achieve the most efficient power

management.

The Adapters keep network maintenance cost low and eliminate usage

barriers. It is the easiest way to upgrade a network from 10 to 100Mbps.

The product is highly integrated and requires no "glue" logic or external

memory.

It includes an interface for a boot ROM and can be used in diskless

workstations, providing maximum network security and ease of

management(Exclude TF-3239DL).

They also support full-duplex operation, making possible 200Mbps of

bandwidth at no additional cost. The Adapters support both 10Mbps

and 100Mbps network speed, 100Base-TX operate on twisted pairs of

Category 5 UTP and 10Base-T operate on Category 3, 4, 5 UTP. The

Adapters use Auto-Negotiation technology to detect the network speed.

Extensive driver supports for including commonly used network

operation system Netware, Win9x,Win2000, Windows NT, and TCP/IP

are available.

Whatever your requirements are ease of installation, superior

performance, or responsive support backed up by unlimited technical

support, the Product is the superior choice.

Features & Benefits

Ø

Integrated Ethernet MAC, Physical chip and transceiver in one

chip

Ø

Compliant to PCI Revision 2.1/2.2

Ø

PCI local bus single-chip Ethernet controller

Ø

Supports PCI clock 16.75MHz-40MHz

Ø

Supports a 32-bit general-purpose timer, referenced by the

external PCI clock source, and timer-interrupt

Ø

Includes a programmable, PCI burst size and early Tx/Rx

threshold

Ø

Supports PCI target fast back-to-back transaction

Ø

Supports digital and analog loopback capability on both ports

FCC STATEMENT

The adapter has been tested and found to comply with the limits for

a class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following measures:

Ø

Reorient or relocate the receiving antenna.

Ø

Increase the separation between the equipment and receiver.

COPYRIGHT & TRADEMARKS

Specifications are subject to change without notice. is a

registered trademark of TP-LINK Technologies Co., Ltd. Other

brands and product names are trademarks or registered trademarks

of their respective holders.

No part of the specifications may be reproduced in any form or by

any means or used to make any derivative such as translation,

transformation, or adaptation without permission from TP-LINK

Technologies Co., Ltd. Copyright © 2005 TP-LINK Technologies Co.,

Ltd. All rights reserved.

Ø

Consult the dealer or an experienced radio/TV technician for

help.

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including

interference that may cause undesired operation.

EC DECLARATION OF CONFORMITY (EUROPE)

In compliance with the EMC Directive 89/336/EEC, the adapter

meets the requirements of the following standards:

Ø

EN55022

Ø

EN55024

SAFETY NOTICES

Caution:

Do not use this product near water, for example, in a wet basement

or near a swimming pool.

Avoid using this product during an electrical storm. There may be a

remote risk of electric shock from lightning.

Advertising
This manual is related to the following products: