TP-Link TL-R402M - Manual (Page 38)

TL-R402M Cable/DSL Router User Guide
( www.tp-link.com ).
2. Run a TFTP Server on a PC on your LAN, and take the file in the TFTP server’s
path.
3. Type the downloaded file name into the File Name box.
4. Type the IP address of the PC that runs the TFTP server in the TFTP Server’s IP
Address field.
5. Click the Upgrade button.
Firmware Version - displays the current firmware version.
Hardware Version - displays the current hardware version. The hardware version
of the upgrade file must accord with the current hardware version.
Note:
1. Do not turn off the router or press the Reset button while the firmware is
being upgraded.
2. The router will reboot after the upgrading has been finished.
5.9.2 Factory Defaults
This page (shown in figure 5-31) allows you to restore the factory default settings for the
router.
Figure 5-31 Restore Factory Default
Click the Restore button to reset all configuration settings to their default values.
• The default User Name: admin
• The default Password: admin
• The default IP Address: 192.168.1.1
• The default Subnet Mask: 255.255.255.0
Note
: Any settings you have saved will be lost when the default settings are restored.
5.9.3 Reboot
This page (shown in figure 5-32) allows you to reboot the router.
Figure 5-32 Reboot the router
Click the Reboot button to reboot the router.
- 34 -