TomTom 4EN42 - Manual (Page 7)

7
Installing in your car
Your TomTom Start navigation device has an integrated mount. See the printed installation poster
included with your product for more information.
To install your device, do the following:
1. Make sure that both the integrated mount and your windscreen are clean and dry.
2. Plug the USB car charger into the power supply on your dashboard.
3. Connect the USB cable to the car charger and your TomTom device.
4. Press the suction cup of the mount firmly against the windscreen on an area where the glass is
flat.
Important: Place the integrated mount so that it does not interfere with your view of the road
or of any of the controls in your car.
5. Twist the rubber grip near the base of the mount in a clockwise direction until you hear a click.
Your navigation device is now installed. The next step is to switch it on and answer a few set-up
questions.
Switching on and off
To switch on your navigation device, press and hold the On/Off button until you see the start-up
screen. The first time you switch on your device, you have to hold the button down for up to 15
seconds.
Setting up
Important: Take care to select the correct language as the language you choose will be used for
all text on the screen.
When you first switch on your device, you have to answer a few questions to set up the device.
Answer the questions by tapping the screen.
GPS reception
When you first start your TomTom Start navigation device, the device may need a few minutes to
determine your GPS position and show your current position on the map. In future, your position
will be found much faster, usually within a few seconds.
To ensure good GPS reception, you should use your device outdoors. Large objects such as tall
buildings can sometimes interfere with reception.
Read me first