Thermador CIT30 - Manual (Page 6)

7
Installation procedure
For safety reasons, the heat shield must be properly installed. This prevents some
components from overheating, avoiding the recirculation of hot air from the
cooktop.
The heat shield is the same width as the cooktop.
For shipping, it is screwed to the burner box.
After unpacking the cooktop, unscrew the heat shield (see illustration).
Screw the heat shield to the base of the burner box using the preĆdrilled holes, as
shown in the illustration.
The cooktop is 3 1 /
3
 (85 mm) high. Once the heat shield has been installed, the
total height of the cooktop is 5 1 /
3
 (135 mm).
d
CAUTION Installing
the heat shield
Transport
Installer