Topfield TF6400IR - Manual (Page 34)

28 Service Search
5. Finally set the Motor Control option to Store to save the
tuned position when the receiving quality is best
There are more motor control options for installers, but this
guide does not describe them. If you are an installer, refer them
to the manual about the STAB rotor.
4.1.3 Configuring USALS settings
USALS (Universal Satellite Automatic Location System), also
known as DiSEqC 1.3, calculates the positions of all available
satellites from your location. Compared to DiSEqC 1.2, it is no
longer required to manually search and store every satellite
position. Just pointing to a known satellite position is enough.
This position will act as a central point. The USALS will then
calculate positions of visible satellites.
To use the USALS protocol, se-
lect the Installation > USALS
Setting
menu. You should see
a screen like the left figure.
At first you have to set the Mo-
torized DiSEqC 1.3 option to En-
able .
To get every satellite position calculated, perform the following
steps:
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Enter your location to the My Longitude option and the
My Latitude option with the ❜, ❞ and numeric buttons.
3. Enter the position of your selected satellite to the Satellite
Angle option if it is not correct.