TANDBERG Movi 3.0 D1440902 - Manual (Page 7)

D1440902 TANDBERG MOVI USER GUIDE
7
Contents Getting started Contacts Status Settings Troubleshooting Status
Using the keypad (DTMF)
When to use the keypad
Dual-tone multi-frequency (DTMF) signaling is used for telephone calls
in the voice-frequency band. A tone is sent representing each number
pressed on the keypad.
The tone-based keypad in Movi has several uses, notably:
• The keypad can be used to create and/or enter passwords for
multi-part conferences.
• Setting up a new conference may in other ways involve equipment
that requires DTMF.
• Voice systems frequently have tone-based menu navigation (such
as, “To speak to an operator, please press 1”).
How to use the keypad
on the video pop-up toolbar brings up the keypad. You may then
enter a number using the mouse.
Note: Sending DTMF may fail if the microphone is muted.
Using the keypad during conferences
The keypad may also be used for changing the layout of your
video window and far-end camera control during conferences.
Note: This feature relies on the TANDBERG MCU, which may
or may not be part of your TANDBERG setup. If in doubt, talk to
your IT administrator.
When the keypad is active during multi-part conferences, you
may:
• Press 2 or 8 to change the layout.
• Press 4 or 6 to change which participant appears in the
largest pane.
• Press 1 or 7 to enable far end camera control.
1 and 7 will then zoom in and out if supported
2, 4, 6, and 8 will work as arrows to move the camera of
the participant in the largest pane.