Universal Scheu Company POWER PAK 445 - Manual (Page 6)

Item Item Item Qty Qty Qty Description Description Description Item Item Item Qty Qty Qty Description Description Description
A 4 Button Head Cap Screw M10 X 2 D 4 Lock Washer M10
B 4 Flat Washer M10
Fully tighten the hardware before you put the dumbbells into the installed dumbbell bases on the stand.
Maintenance Maintenance Maintenance
Equipment must be regularly examined for damage and repairs. The owner is responsible to make sure that regular maintenance is done. Worn or damaged
components must be replaced immediately or the equipment removed from service until the repair is made. Only manufacturer supplied components can be
used to maintain and repair the equipment.
This product, its packaging, and components contain chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. This Notice
is provided in accordance with California’s Proposition 65. If you would like additional information, please refer to our Web site at www.nautilus.com/prop65
Adjustable Adjustable Adjustable Dumbbell Dumbbell Dumbbell Maintenance: Maintenance: Maintenance:
The adjustable dumbbell with SelectTech® techology is a very low maintenance product. However, you can use these instructions to keep the product in its best condition.
1. If your SelectTech® dumbbell handle assembly, plates or base become dirty, you can clean them with a cloth lightly dampened with warm water and a small amount
of mild soap. Wipe dry with a separate cloth.
2. The adjustable dumbbell is internally lubricated and will not require more internal lubrication. The contact between weight plates and selection discs is not lubricated
but has naturally low friction. Lubrication is usually not necessary. If you feel it is necessary to lubricate the weight plates and/or selection discs, use only a “food
grade”silicon lubricant.
Do not use any solvents, harsh detergents, chemicals or bleach on this product - this can damage the materials, resulting in degradation of the product’s
performance or strength.
Never attempt to disassemble the dumbbell handle or base assembly – the product is not designed to be user serviced. Doing so will void the manufacturers
warranty. Contact Nautilus, Inc. directly for service.
TTTroubleshooting roubleshooting roubleshooting
Problem Problem Problem Solution Solution Solution
Dumbbell handle does not fully go into base when no
plates are attached. 1. Make sure that the adjustment knobs are set directly to the number 4.
2. Make sure that the weight plates are seated correctly in the base assembly.
Dumbbell handle does not fully go into base when
plates are attached. 1. Make sure that the plates that are still in the dumbbell base are in their correct spots and not moved to
different support slots. This may be blocking the dumbbell from fitting back into the base.
666