Unisar Digital Thermometer - Manual (Page 4)

6 7
INSTRUCTIONS FOR USE
1. Turn on the baby’s thermometer by pressing
the power button for approximately 2 sec-
onds. The LCD display will show the
temperature data.
3. Turn on the Parents’ Unit by pressing the
power button for approximately 2 seconds.
The LCD display will show it is searching for
the signal from the thermometer. After
several seconds the LCD display will show
the temperature reading received from the
thermometer.
4. To switch between Celsius and Fahrenheit, press
the (S) button for approximately 2 seconds. Both
units have to be independently set.
Buzzer: An alarm for
abnormal temperatures
Warning Light: Alarm
LCD Screen
Set Button:
A. Push 2 seconds to
switch between
°C & °F.
B. Choose high
temperature (fever
warning
temperature point
Warning Cancel Button:
Temporarily cancels buzzer sound
Power Button:
A. Push 2 seconds to turn power on or off
B. Push to set the fever alarm temperature
LCD Screen
Set Button:
Push 2 seconds to
switch between
°C & °F
Power Button:
Push 2 seconds to turn
power on or off
2. Clip the thermometer to the
baby’s diaper, pajamas, or
our special belt, approxi-
mately one inch (2-3 cen-
timeters) to the left of the
belly button. If you are using
the belt provided, it’s best to
fasten it over the diaper or
pajamas to avoid any
possible irritation. Make
sure the temperature sensor
on the back of the unit is in
contact with the skin and that
your baby is wearing clothing
covering the stomach to avoid the loss of
body heat.
Child’s Thermometer
Parents’ Unit