Ultra electronic MAGICARD Sicura Laminator - Manual (Page 14)

Quick Start Guide Ultra Electronics Card Systems
Page 14 MAGICARD Sicura Laminator
IMPORTANT NOTE FOR SETTING UP YOUR RIO/TANGO PRINTER DRIVER TO WORK
WITH THE SICURA LAMINATOR –
Please select the appropriate option in your printer driver for best results.
It is necessary to make the correct settings to the overcoat page in your printer driver
when using a laminator.
If your printer is installed with a custom Holokote key, or you are using the standard
UltraSecure logo you can select the UltraShield box under the Security Options. This
selection uses selective overcoat application to give a 3D security logo effect.
If you are overlaminating with no additional security option, ensure the overcoat
enabled box is not checked.
Interfacing to a RIO/TANGO Printer G