Uniden 7000A - Manual (Page 34)

34
REMOTE OPERA
TION
CHANGING THE REMOTE OPERATION SECURITY CODE
The remote operation security code is preset to 798, but you can
change it by following these steps.
1. Hold down code set until the DTAM beeps once. appears.
2. Press again. (security code) and the digits of the
current code appear in sequence, then the first digit reappears.
For example, when the security code is 798, the display shows
(security code) , , , then reappears.
3. Repeatedly press or to set the first digit, then
press . The second digit appears.
4. Press or to set the second digit, then press
The third digit appears.
5. Press or to set the third digit, then press
The DTAM sounds a long beep and announces the
security code.
REMOTE OPERATION
NOTE:
Be sure to set each digit within 8 seconds. Otherwise, you must start
over from Step 1.