Uniden GPS402 - Manual (Page 8)

8
TM
Permanent Dashboard or Console Mounting
To.mount.the.device.on.a.rough.surface,.such.as.your.
dasboard.or.console,.use.the.surface.mount.disk.that.
came.with.your.device..This.disk.permanently.mounts.in.
your.car.and.provides.a.stable.base.for.the.suction.cup.
mount..
Determine.the.best.location.for.the.surface.mount.disc..
Attach.the.device.to.the.support.arm...Place.the.suction.
cup flat against the surface, and adjust the position so
you.can.easily.see.the.display.screen.but.your.driving.
view.is.not.obstructed.
1.
Clean.the.surface.where.you.plan.to.mount.the.disc..Be.
sure.to.remove.all.protecterants,.wax,.and.grease.
Carefully.peel.the.protective.sheet.
from.the.bottom.of.the.surface.
mount.disc.to.expose.the.adhesive..
Position.the.disc.above.the.surface.
in.the.desired.location,.Press.the.
disc firmly against the surface,
making.sure.that.all.parts.of.the.
disc.have.good.contact.with.the.surface...Gently.tug.on.the.
disc.to.test.the.adhesive.before.mounting.the.support.arm.
Press the suction cup firmly
into.the.surface.mount.disc.and.
push.the.suction.lock.down.
towards.the.suction.cup..
To.release.the.suction.cup,.
pull.the.lock.back.towards.the.
support.arm.and.lift.the.plastic.
tab.. Important:.be.ready.to.
support.the.device.when.it.
releases.from.the.windshield.
Connect.the.DC.power.cord.to.
the. 11-15VDC.jack..Then,.insert.the.cigarrette-lighter.plug.
into.a.standard.1-volt.outlet..The.device.automatically.
turns.on.when.you.connect.the.power.
2.
3.
4.
5.
6.
7.
NOTE:.
The.surface.mount.disc.is.designed.to.
permanently.stick.to.most.surfaces..Attempting.
to.remove.the.disc.may.cause.damge.to.the.
surface..Be.certain.you.have.the.disc.in.the.
desired.location.before.exposing.the.adhesive.