Asus T5-P5G41E - Manual (Page 62)

4-16 Chapter 4: BIOS setup
4.4.2 Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an
item then press <Enter> to display the sub-menu.
North Bridge Configuration
Memory Remap Feature [Enabled]
Allows you to enable or disable the remapping of overlapped PCI memory
above the total physical memory. Configuration options: [Disabled] [Enabled]
Configure DRAM Timing by SPD [Enabled]
Allows you to enable or disable configurating DRAM Timing by SPD.
Configuration options: [Enabled] [Disabled]
Initiate Graphic Adapter [PEG/PCI]
Allows you to select the graphics controller as the primary boot device.
Configuration options: [IGD] [PCI/IGD] [PCI/PEG] [PEG/IGD] [PEG/PCI]
IGD Graphics Mode Select [Enabled, 32MB]
Allows you to select the amout of system memory used by the Interanal
graphics device. Configuration options: [Disabled] [Enabled, 32MB] [Enabled,
48MB] [Enabled, 64MB] [Enabled, 128MB] [Enabled, 256MB]
GTT Graphics Memory Size [No VT mode, 2MB]
This item is not user- configurable.
DVMT Memory [256MB]
Allows you to select the DVMT memory.
Configuration options: [128MB] [256MB] [Maximum DVMT]
Advanced Chipset Settings
WARNING: Setting wrong values in below sections may
cause system to malfunction.
North Bridge Configuration
South Bridge Configuration
Configure North Bridge
features.
BIOS SETUP UTILITY
Advanced
North Bridge chipset Configuration
Memory Remap Feature [Enabled]
Configure DRAM Timing by SPD [Enabled]
Initiate Graphic Adapter [PEG/PCI]
IGD Graphics Mode Select [Enabled, 32MB]
GTT Graphics Memory Size [No VT mode, 2MB]
DVMT Memory [256MB]
Protect Audio Video Path Mode [Lite]
ENABLE: Allow
remapping of
overlapped PCI memory
above the total
physical memory.
DISABLE: Do not allow
remapping of memory