United States Stove Company 2007 - Manual (Page 6)

6
CHIMNEY CONNECTION CHIMNEY CONNECTION CHIMNEY CONNECTION CHIMNEY CONNECTION CHIMNEY CONNECTION
Two basic types of chimneys are approved for
use with solid fuel. Factory-built and ma-
sonry. Factory-built chimney must comply
with UL/ULC standard in the US and Canada.
Do not expect your stove or furnace to create
draft. Draft is not a function of the appliance.
Draft is purely a function of the chimney. Mod-
ern stoves and furnaces are much more air-
tight and efficient than those of the past, and,
therefore, require greater draft. A minimum of
.05" measured in water column (gauges to
measure chimney draft are readily available
at stove shops and are economical to pur-
chase or rent) is required for proper drafting to
prevent back-puffing, smoke spillage, and to
maximize performance.
Chimneys perform two functions - one of which
is apparent: The chimney provides a means
for exhausting smoke and flue gases resulting
from combustion of the fuel. Secondarily,
though, the chimney provides "Draft" which
allows oxygen to be continuously introduced
into the appliance, so that proper combustion
is possible. As of April 1, 1987, all wood
heaters and furnaces manufactured by United
States Stove Company should be installed
using a factory-built chimney that meets the
"Type HT" requirement of UL 103 (when a
factory-built chimney is used).
A chimney connector shall not pass through
an attic, roof space, closet, floor, ceiling, or
similar concealed space. Where passage
through a wall or partition of combustible con-
struction is desired, the installation must con-
form with NFPA 211 or CAN/CSA-B365.
Fig. 6 Fig. 6 Fig. 6 Fig. 6 Fig. 6
NON-COMBUSTIBLE WALL
COLLAR
ELBOW
PIPE
THIMBLE
PIPE
Fig. 5 Fig. 5 Fig. 5 Fig. 5 Fig. 5
CHIMNEY CAP MANDATORY
REFER TO CHIMNEY
MANUFACTURER'S
PARTS AND INSTRUC-
TIONS
2 FT. MIN.
3 FT MIN.
11 FT. MINIMUM
10 FT.
PIPE
DAMPER
FLOOR PROTECTOR
DAMPER
FLOOR PROTECTOR