Uniden UNIDEN - Manual (Page 27)

2. Press the EXIT/ALERT key while receiving signals when
driving in the same false area.
The function is switched on/off, and the display changes as
follows:
Note: • If the signal strength is more than the predefined
level, the vehicle speed will be indicated on the
display instead of the right 3 characters “STP”.
• The EXIT/ALERT key functions only at the present
false area to switch from GPSRD operation to
conventional radar detector operation.
Trap Point
The Trap Point is a user programmable location that can be used
to mark a common speed trap location. Once a location is
marked, the next time you approach the location, an alarm will
sound. You can mark up to 1,000 locations.
Press the SELECT/TRAP key at the
location you want to mark. After
“Trap” and the marked number
indication disappears from the
LED display, the display returns
to the Normal mode marked as
shown below.
When you approach the previously marked location, the detector
sounds alert tones and changes the LED color on the display in 3
levels as follows.
23
GREEN
GREEN
[ EXIT/ALERT ]SW
GREEN
ON OFF
2 sec later
GREEN
GREEN
GREEN
2sec later
[ SELECT/TRAP ]SW
Distance Alert LED Alert
(Radius/Mile) Tone Time Color Display Time
Level 1 0.5 3 sec GREEN 3 sec
Level 2 0.25 3 sec ORANGE 3 sec
Level 3 0.1 3 sec RED 3 sec
US076Z (GPSRD) OM 9/4/01 13:39 Page 23