U-Line BI-98 - Manual (Page 5)

02/2005 5 www.U-LineService.com
BI-98 Ice Maker
Reversing the Door
All units may be left- or right-hand opening.
Note: The grille should not yet be installed. If it has been
installed, remove it for door reversing. See Page 10.
To reverse the door:
1. Remove top hinge from cabinet (three screws). See
Figure 4. Hold door to keep it from falling.
2. Lift the door off the bottom hinge.
3. Remove bottom hinge from cabinet (two screws). See
Figure 5. Remove screws on opposite side of cabinet
(Figure 6). Note that there may be a nut behind one or
both screws on either side.
4. Install hinge on opposite side, bottom of cabinet. See
Figure 7. Replace nut on back side where installed.
Align hinge outer edge with cabinet before tightening
screws.
5. Relocate plastic spacer/
bushing on bottom of
door to opposite side,
and place door on
bottom hinge pin. See
Figure 8. Clean out
bushing hole in door
bottom with a
screwdriver if necessary.
6. Remove plastic hole
plug from door handle
and relocate on
opposite side. See
Figure 9.
7. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge. See Figure 9.
8. Remove three plastic
screw plugs from hinge
holes, top of cabinet,
opposite side. Be careful
not to scratch cabinet.
See Figure 10.
9. Place door on lower
hinge pin. Invert and
install upper hinge on
door.
Figure 4 Figure 5
Figure 6 Figure 7
Bushing
Figure 8
Plastic
Plug Hole
Plastic
Plug Hole
Hinge
Screw
Right Side
Door Swing
Right Side
Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
Figure 9
Figure 10