Uniden DCT 746M - Manual (Page 41)

P H O N E B O O K [ 4 0 ] w w w . u n i d e n . c o m
Storing Caller ID Messages in the Phonebook
Messages shown in the Caller ID list (see page 47) can be stored in the phonebook.
The phone number and name of the party on the Caller ID list can be stored in
memory.
1) When the phone is in standby mode, select the Caller ID message to be stored.
2) Press select/
/audio tone. S to r e/ Ed i t N am e appears.
If the Caller ID message is already stored in memory, you will hear a beep and
T h is da t a is al r ea d y st o re d !! appears. The number will not be stored.
3) To complete the setting, follow the steps 4-9 in “Storing and Editing Phone
Numbers, Names, Distinctive Rings and Speed Dial” on page 37.
Storing a Redial Record
1)With the phone in standby mode, press pause/redial.
2) Press pause/redial repeatedly to display the number to be stored.
3) Press select/
/audio tone. S to r e/ Ed i t N am e appears.
4) To complete the setting, follow the steps 4-9 in “Storing and Editing Phone
Numbers, Names, Distinctive Rings and Speed Dial” on page 37.
•If a call comes in via a
telephone system that
does not offer Caller ID
service, no information
is stored.
•If the Caller ID
message was received
as a private/unknown
number, or the
message does not have
the number, you
cannot store the
message in the
phonebook. If it was
received as private/
unknown name, the
message will be stored
as <No Name>.
•Even if all 80 memory
locations are full, the
message will be stored
in the phonebook.
However, the message
will be erased from the
Caller ID list.
note
PH
ONEBOOK