Uniden BC796D APC0 25 - Manual (Page 53)

47
5. Select the channel to store the information into.
2:TRUNK CHANNEL
Use the scroll bar to select a channel within the bank to store a system frequency, then
press E.
6. Store the channel information
1:FREQUENCY
Enter the frequency for the channel, then enter an Alpha Tag for the channel.
Repeat Steps 5 and 6 to store the rest of the frequencies for the system. Then, see
“Programming Talkgroups.”
Programming Type I and IIi Hybrid Systems
To program a Type I or IIi Hybrid system, you need to know the system’s fleet map in
addition to the frequency information for the system. Fleet map information is usually
provided with the frequencies for the system.
1. Select the trunk programming mode.
2:SCAN OPTION → 2:TRUNK
2. Use the scroll bar to select the bank you want to program, then press E.
1:TRUNK TYPE → 1:ON
3. Select the following trunk type for Motorola Type I Systems:
2:TYPE1
Motorola Type I and IIi Hybrid Systems
4. Enter the fleet map information.
Your scanner has the most common fleet maps preprogrammed. Refer to Appendix for a
complete list of these fleet maps.
Use the scroll bar to select the preprogrammed fleetmap 1-16 or, if the fleet map does
not match a preprogrammed set, select USER CUSTOM. Then, use the scroll bar to
select the size code for each block.
5. Select the channel to store the information into.
2:TRUNK CHANNEL
Use the scroll bar to select a channel within the bank to store a system frequency, then
press E.
6. Store the channel information
1:FREQUENCY
Enter the frequency for the channel, then enter an Alpha Tag for the channel.
Repeat Steps 5 and 6 to store the rest of the frequencies for the system. Then, see
“Programming Talkgroups.”
BC796D(NEW) 10/20/03 11:30 AM Page 47