Unitech PA500 - Manual (Page 11)

Chapter 1 Getting Started
5
Setting up the PA500
Perform the following set up tasks to begin using your device:
• Install the battery pack
• Charge your device
• Power on the PA500
Installing the Battery
WARNING!
There is a risk of fire and burns if the battery pack is handled
improperly. DO NOT disassemble, crush, puncture, short external
contacts, or dispose the battery pack in fire or water. DO NOT attempt
to open or service the battery pack. Dispose of used batteries
according to
the local recycling guidelines in your area.
A backup battery cell is embedded into your device to prevent data loss when the
removable battery
pack is removed or completely discharged. Th
e backup battery will keep the data and system settings up
to 1 hour if the main battery is removed.
NOTE:
To enable the internal battery cell to provide backup power supply, charge your device
with the main battery pack for at least three and a half hours.
1. Position the battery pack, making sure the battery pack fits the shape of the battery
compartment.
2. Slide the battery pack into the battery bay. The battery pack locks to the chassis with an audible
click.
3. If you remove the main battery and plug it back before the backup battery lost
power, PA500 will be warm start.
4. If you remove the main battery and plug it back after the backup battery lost power,
PA500 will be clean booted.