Unwind DT-920 - Manual (Page 6)

LISTENING TO PRESET STATIONS
Program stations as described in "AUTOMATIC OR MANUAL TUNING."
Using the TUNING "UP" or "DOWN" button Using the PRESET button
1. Press the CH/FREQ button to select the channel mode.
("FREQ" disappears.)
2. Press the TUNING "UP" or "DOWN" button until the
desired channel number appears on the display.
- The
preset station for the selected channel number
can be heard.
1. Press two PRESET buttons (1 - 0) to select the desired
channel number.
Example:
CH01 ... Press "0" and "1".
CH05 ... Press "0" and "5".
CH12 ... Press "1" and "2".
CH39 ... Press "3" and "9".
CH40 ... Press "4" only.
You cannot enter preset numbers above CH40.
- The preset station for the selected channel number can
be heard.
- If a channel number which has not been preset is
entered,"----" appears for 2 seconds and the previous
station is selected.
Changing the reception frequencies
It is not necessary to perform this procedure in U.S.A and CANADA.
1. Select the band to be changed.
2. Turn the power off.
3. While pressing the BAND button, press the POWER button.
AM: 520 - 1710 kHz (10 kHz steps) 522 - 1710 kHz (9 kHz steps)
FM: 87.9 - 107.9 MHz (200 kHz steps) 87.5-108.0 MHz (50 kHz steps)
- The preset stations will be retained in the memory even
if the unit is turned off.
If the memory contents are lost due to a power failure or
other condition, preset the stations again.
WHAT TO DO IF ...
If the operation of the unit or display is not normal, or you
wish to clear the contents of the memory, disconnect the
power cord from the AC outlet, then press the RESET
button (rear of the unit) for at least 20 seconds.
-5-