Uniden DSS2115 - Manual (Page 18)

14
If a handset is registered at
any time as handset 1, all
other handsets will need to
be registered again from Step
1.
The original handset supplied with the Main Base is already registered as Handset 1, this leaves Handset
numbers 2 - 7 available. It is very important to allocate each handset a different number to enable functions
such as Call Transfer.
After Registration the
handset number is shown on
the Display screen either
during a call or while the
handset is charging (Fig 4).
The Registration process
needs to be completed within
15 seconds, 5 beep tones will
indicate that the time has been
exceeded. Please start the
process again.
Handset
Registration
number
displayed
HANDSET 1
NEW:
0
TOTAL: 0
TALK HIGH 1
Fig 3.
Fig 4.
Charging On a Call
REGISTER AS
HAND #2
Fig 2.
Fig 1.
Registration Process
Follow this process for each additional Handset (DSS2105) that needs to be registered to the Main Base
or for registering your Main Handset.
1. Remove the handset from its charger
2. Press flash/reg on the handset (Fig 1).
3 Press the number 2 (Fig 2) for handset 2.
4. Place the handset in the Main Base Unit (Fig 3).
5. Press and hold the Registration button located on the back of the Main Base unit near the DC
power jack (Fig 3). Hold the Registration button in until a long beep confirms the handset has
been registered.
REGISTRATION
If you have additional
handsets, repeat the same
process, but at Step 2 select
a number from 3 - 7 to
register the next handset as.