Uniden GPS105 - Manual (Page 3)

The Quick Start Guide pages are designed to allow you to install and operate your GPS105 as quickly as possible,
however it does not attempt to explain any of the advanced features of the GPS105 unit.
The GPS105 is designed to fit into a standard car stereo (DIN) fitting.
You may also use the supplied bracket & fasteners to mount the GPS105 in other locations.
!
!
The GPS105 runs on positive 13.8V DC, negative earth.
The positive wire is fused at 2 Amps.
With some vehicles, the window tint may prevent the GPS Internal Antenna from
acquiring a signal. In such a case, an optional External GPS antenna may be used.
INSTALLING YOUR GPS105
Please consider the following before installing.
The GPS105 uses a UHF antenna and a GPS internal antenna.
For a UHF antenna (not supplied) please follow the manufacturers instructions for installation.
It is recommended that the UHF and GPS antenna are mounted separately.
If placing the GPS internal antenna on the dashboard or the rear parcel shelf then ensure the UHF antenna is
fitted towards the opposite end of the vehicle or fitted centre of the roof top.
!
ii
Guide
Quick Start