Chimney maintenance, Service hints – United States Stove Company CSSU User Manual

Page 6

Advertising
background image

WARNING!

NEVER STORE FLAMMABLE LIQUIDS,

ESPECIALLY GASOLINE. IN THE

VICINITY OF THE HEATER.

CAUTION!

OVERFIRING THE APPLIANCE MAY

CAUSE A HOUSE FIRE. IF A UNIT OR

CHIMNEY CONNECTOR GLOWS, YOU

ARE OVERFIRING.

CAUTION!

NEVER USE GASOLINE, GASOLINE-TYPE

LANTERN FUEL, KEROSENE, CHARCOAL

LIGHTER FLUID, OR FLAMMABLE

LIQUIDS TO START OR "FRESHEN UP" A

FIRE IN THE HEATER.

CAUTION!

USE COAL ONLY. DO NOT USE

DRIED LUMBER, TREATED WOOD

ARTIFICIAL OR PRESSED LOGS.

WARNING!

NEVER OPERATE THIS HEATER WITH THE

FUEL DOOR OPEN.

WARNING!

DO NOT OBSTRUCT THE SPACE BENEATH

THE HEATER

Chimney Maintenance

The chimney connector and chimney should be inspected at
least twice monthly during the heating season to determine
if a creosote or soot buildup has occurred.

If there is any accumulation, it should be removed. Failure to
remove creosote may cause a house fire. Soot may be
removed by using a chimney brush or other commonly
available materials.

Chimney fires burn very hot. If the chimney connector should
glow red, immediately call the fire department, then reduce
the fire by closing the inlet air control and pour a large
quantity of coarse salt, baking soda or cool ashes on top of
the fire in the firebox. CAUTION: A chimney fire may cause
ignition of wall studs or rafters which you thought were a safe
distance from the chimney. If you have a chimney fire, have
your chimney inspected by a qualified person before using
again.

Service Hints

Do not expect a heater to draw. It is the chimney that creates
the draft. Smoke spillage into the house or excessive buildup
of water or creosote in the chimney are warnings that the
chimney is not functioning properly. Correct problem before
using heater. Possible causes are:

The connector pipe may push into the chimney too far,
stopping the draft. (Fig. 5)

Do not connect two heaters into the same chimney flue.

The chimney used for a heater must not be used to
ventilate the cellar or basement. If there is a cleanout
opening at the base of the chimney, It must be closed
tightly.

1.

2.

3.

4.

5.

If the chimney is operating too cool, water will condense
in the chimney and run back into the stove. Soot forma-
tion will be rapid and may block the chimney. Operate
the heater at a high enough fire to keep the chimney
warm preventing this condensation.

If the fire burns well but sometimes smokes or burns
slowly, it may be caused by the chimney top being lower
than another part of the house or a nearby tree. The wind
blowing over a house or tree, falls on top of the chimney
like water over a dam, beating down the smoke. The top
of the chimney should be at least 3 feet above the roof
and be at least to 2 feet higher than any point of the roof
within 10 feet (Fig. 7).

NOTE:

FOR YOUR SAFETY, WE RECOMMEND INSTALLING SMOKE DETECTORS IN YOUR HOME IF NOT

ALREADY INSTALLED.

CAUTION! Do not touch the heater until it has cooled.

6

Advertising